Remove the plastic protective wrapping from the band.

For link removal above the logo, place resizing tool on the left side of the band. Align the tool’s pin with the band’s pin hole, twist until the head of the band’s connector pin begins to push out of the right side.

NOTE:
The resizing tool will not fully push the entire pin out. Twist the tool until the head of the pin pushes out, then remove with fingertips.

For link removal below the logo, place resizing tool of the right side of the band. Aligh the tool’s pin with the band’s pin hold, twist until the head of the band’s connector pin begins to push out of the left side.

Repeat and remove links as needed for best fit.

NOTE:
You cannot remove the links attached to the hardware of the band.

To reassemble above the logo, place tool on the right side of the band. Insert the connector pin with the head of the pin facing the right side. Twist until flush.

To reassemble below the logo, place tool on the left side of the band. Insert the connector pin with the head of the pin facing the left side. Twist until flush.

Get the size you need for your watch.

Insert provided tool into pinhole to release the connector.

Lift connector off.

Attach with middle silver connector notch facing up.

Insert pin into one side of the connector.

Gently push down the other end.